ICE MotorCardboard Battery MockupMotor MountBattery RackBatteries InstalledBattry Install & Wire-upTilt-up Charger MountSolar ChargerTank Shell
OwnerAndy Nyman
LocationLittleton, Colorado US map
Email email image
Vehicle1989 Yamaha FZR 600
One of my old road race bikes MRA #128
Sold the ICE motor.
MotorD&D Motor Systems, Inc. ES-15A-6 Series Wound DC
* 48-72 VDC Series Motor
* 9 HP @ 72V Continuous Rated
* 65 Ft /Lbs Torque Peak
* 30 HP Peak with 450 Amp Controller

* 7/8" Single-Shaft, 6.7" Dia by 12.28" Long
* Actual weight 62 lbs
DrivetrainDirect drive- 13/60 Sprockets (4:62)
#40 Chain, (420)60t Rear Sprocket.
12,13,14,15,16- #40- 7/8" bore Primary Sprockets.
ControllerAlltrax 7245
72 Volt 450Amp Programmable via RS232 comm port using PC or Laptop.

Contactor- Kilovac EV200
Batteries6 C & D Technologies UPS 12-170, 50Ah, 12.00 Volt, Lead-Acid, AGM
Round one starter batteries. Can't wait to upgrade to?
System Voltage72 Volts
Charger H01200100-US-W11
12V 10A Lead Acid Smart Charger
Quantity-6 on-board
DC/DC Converter None
Auxiliary 12 Volt 12Ah battery and on-board 1amp charger.
InstrumentationOEM MPH/ODO, Digital voltmeter.
May add Pak-TraKer or?
Top Speed65 MPH (104 KPH)
With 15/60 (4:00) Gearing
55MPH 13/60 (4:62) Gearing
Goal 80-90MPH (Better batteries)
AccelerationPulls hard to 45MPH then tapers off.
Range15 Miles (24 Kilometers)
The batteries are not that good. Need more volts, amps and lighter weight.
Seating Capacity1 Adult
Curb Weight475 Pounds (215 Kilograms)
I can't wait to get the lead out!
TiresDunlop K591 Sport Elite
Conversion TimeMany long nights and weekends. It's been a great project, I have learned a lot!
Conversion CostAround $2000 so far, not including the bike which was one of my old road race bikes.
Additional Features* Small solar charger mounted on tail for 12v lighting battery.
* On-board chargers fit under OEM tank shell and tilt up for battery access. 120v charger plug fit perfect in the frame radiator inlet.
* Aluminum L-Angle battery brackets can be modified when upgrading batteries.
* I'm very happy with my 6061 aluminum motor mount.
* HID head lights and LED marker lights, body work and paint to come.

code by jerry